Something About Circuit Breakers

Something About Circuit Breakers

Circuit breakers are necessary, and many experts need them to prevent circuit fire caused by short circuit current.

Miniature circuit breakers are known to protect only from voltage spikes for a short period, whereas the circuit breaker protects overcurrent in the wiring.

If there is over-voltage, it can damage the appliance. However, over-voltage will not cause any fire if a circuit breaker is powering it.

Circuit breakers protect from overcurrent, which can even burn down the house, and this may even happen without overvoltage.

Application of Circuit Breakers 

•      They include being used in industries

•      They include being used in industries, building, and commercial projects for switching of loads.

•      To help keep the electrical components safe and the system safe, it is important to protect the system with the help of circuit breakers.

•      MCB is the most common circuit when it comes to low voltage circuits. There are multiple smaller circuits within a single circuit. Each of them is controlled with an MCB, so only the affected circuit will be disconnected if any issue arises.

All the devices produced by ZHEJIANG YUELONG are carried out in strict accordance with the production process. Therefore, they ensure that there are no errors in the development and sales.

ZHEJIANG YUELON has always proved to provide sustainable solutions that help the customers, and their products are highly efficient and reliable.

Related Posts

What is DC SPD for solar?

What is DC SPD for solar?

DC Surge protective device,protect against lightning surge voltages in solar system (photovoltaic power supply system). These units must be installed in parallel on the DC networks to be protected and provide common and different modes protection. Its installed location are recommended at both ends of the DC power supply line (solar panel side and incerter/converter […]

Selection of a Type 1 SPD

Selection of a Type 1 SPD

Impulse current Iimp 1.         Where there are no national regulations or specific regulations for the type of building to be protected: the impulse current Iimp shall be at least 12.5 kA (10/350 µs wave) per branch in accordance with IEC 60364-5-534. 2.         Where regulations exist: standard IEC 62305-2 defines 4 levels: I, II, III and […]

Components of Surge Protective Devices (SPDs)

Components of Surge Protective Devices (SPDs)

Surge protective devices (SPDs) play a critical role in protecting sensitive electronic equipment from unexpected voltage changes, such as voltage surges and spikes. These sudden voltage spikes can cause significant damage to equipment, leading to costly downtime and repair. In this article, we will explore the different components of Surge protective devices (SPDs) and describe their […]